| Random files - Sailing |
287 views
|
|
Parked on the hill.157 views
|
|
Cleaning and Reassembly111 viewsI disassembled the boat in the fall of 2010 as the trampoline needed sewing. Here I have cleaned the port (lower in the picture) hull and you can see the difference.
|
|
Closeup of the hulls111 viewsJust for recording sakes, the hulls are factory stamped CAN209A and CAN209B.
|
|
Slid the front crossbar onto the tramp and into place103 views
|
|
Starboard rudder details112 views
|
|
Daggerboard details119 viewsNote the loop on the top of the daggerboard. Sized to hold the board flush to the bottom of the hull when hooked on the trapeze wire handle.
Also note the tygon hose wrapped shock cord behind the daggerboard. When the daggerboard is dropped, the elastic/hose is pulled over the top of the daggerboard and squeezes it against the inside of the daggerboard slot. This holds it in place wherever you position it.
|
|
Closeup view of the mainsheet123 viewsNever have come up with a decent traveller system ... someday? I just tie a short piece of rope from the eyelet on the crossbar to the traveller car.
|
|
| Last additions - Sailing |
Rear view of lacing107 viewsJun 27, 2011
|
|
Artsy fartsy picture135 viewsThe cedar debris is from the trees I rubbed when moving the boat from assembly area to the water.Jun 27, 2011
|
|
Can we go sailing now?141 viewsJun 27, 2011
|
|
Sigh109 viewsJun 27, 2011
|
|
Picture perfect90 viewsWell, not quite, no dang wind!Jun 27, 2011
|
|
Closeup view of the mainsheet123 viewsNever have come up with a decent traveller system ... someday? I just tie a short piece of rope from the eyelet on the crossbar to the traveller car.Jun 27, 2011
|
|
Nice ... can't wait to hit the water!109 viewsJun 27, 2011
|
|
Daggerboard details119 viewsNote the loop on the top of the daggerboard. Sized to hold the board flush to the bottom of the hull when hooked on the trapeze wire handle.
Also note the tygon hose wrapped shock cord behind the daggerboard. When the daggerboard is dropped, the elastic/hose is pulled over the top of the daggerboard and squeezes it against the inside of the daggerboard slot. This holds it in place wherever you position it.Jun 27, 2011
|
|
