| Most viewed - Freestyle 474 Catamaran |
Artsy fartsy picture135 viewsThe cedar debris is from the trees I rubbed when moving the boat from assembly area to the water.
|
|
Popped back up ... where's Ian?133 views
|
|
Hiking out on the wire!132 views
|
|
All is good.129 views
|
|
Way ... Way ... Up!128 views
|
|
Closeup view of the mainsheet123 viewsNever have come up with a decent traveller system ... someday? I just tie a short piece of rope from the eyelet on the crossbar to the traveller car.
|
|
Daggerboard details119 viewsNote the loop on the top of the daggerboard. Sized to hold the board flush to the bottom of the hull when hooked on the trapeze wire handle.
Also note the tygon hose wrapped shock cord behind the daggerboard. When the daggerboard is dropped, the elastic/hose is pulled over the top of the daggerboard and squeezes it against the inside of the daggerboard slot. This holds it in place wherever you position it.
|
|
Downhaul114 views
|
|
Slide the rear crossbar onto the tramp and into place112 views
|
|
Starboard rudder details112 views
|
|
Cleaning and Reassembly111 viewsI disassembled the boat in the fall of 2010 as the trampoline needed sewing. Here I have cleaned the port (lower in the picture) hull and you can see the difference.
|
|
Closeup of the hulls111 viewsJust for recording sakes, the hulls are factory stamped CAN209A and CAN209B.
|
|
| 42 files on 4 page(s) |
2 |  |
|
